Yibin Electric Vehicle Maintenance Company
The charging pile industry comes with the development of new energy vehicles. In 2020, the charging pile will be included in the new infrastructure and written into the government work report, which will become the precondition for developing new energy vehicles, stimulating new consumption demand and helping the industry upgrade. Under the exploration of new business model and the guidance of a new round of policies, new channels for the development of charging piles have been opened, ushering in new opportunities. The charging pile industry chain is divided into supply terminals such as equipment manufacturers and power suppliers, operation terminals such as operators and new energy vehicle enterprises, and support terminals such as map navigation and payment functions. The core link is the operation end, which is responsible for the investment, construction and operation management of the charging pile. At present, Chinese funded enterprises, private capital and vehicle enterprises are all involved in the operation.
Yibin Electric Vehicle Maintenance Company
3. Power requirements: ① Input voltage: single-phase 220V; ② Output power: single-phase 220V/5KW; ③ Frequency: 50Hz ± 2Hz; ④ Allowable voltage fluctuation range: single-phase 220V ± 15%; 4. Electrical requirements: ① After the correct connection of plug and socket is confirmed to be successful, the circuit that can be opened and closed with load can be closed to supply power to the socket; ② The leakage protection device shall be installed on the incoming side of the power supply cable; ③ The protection of low-voltage distribution equipment and lines shall meet the relevant provisions in the Code for Design of Low Voltage Power Distribution (GB/50053); ④ For the distribution line of IT system, in case of ground fault, the insulation monitoring device shall send out audio or light signals. In case of the second phase to phase ground fault, the fault circuit shall be cut off by the over-current protection appliance or leakage current action protector; ⑤ In the lighting distribution system, the lighting and socket circuits should not be powered by the same circuit.
Yibin Electric Vehicle Maintenance Company
The country attaches great importance to the development of new energy vehicle charging equipment, and all regions will naturally increase efforts to promote development. Taking Nanning as an example, it is estimated that by 2020, there will be about 21550 new energy vehicles in Nanning. In order to meet the charging needs of the majority of car users, by 2020, Nanning will need nearly 20000 charging poles and nearly 100 charging stations. At present, the development of electric vehicle public charging equipment in Nanning is still in the primary stage. At present, the number of electric vehicles and the number of charging piles are seriously unbalanced, and the phenomenon of vehicles without piles and piles without vehicles occurs from time to time. The main reason is that the all smart service platform has not been built yet and needs further improvement.
Yibin Electric Vehicle Maintenance Company
In order to popularize the application in any industry, it is essential to continuously reduce the cost. This is especially true for photovoltaic enterprises that are still in the cold winter. Photovoltaic power generation was once very expensive, but driven by economies of scale, the cost of photovoltaic power generation has been declining in recent years, and now it is very close to parity. All this depends on the continuous innovation of photovoltaic technology. Theoretically, a 1 square meter sunlight exposure surface can generate 1000 watts of energy at most. If you want to increase the total reception of existing solar panels, you must focus the light, which will cause the panel to burn out due to excessive temperature.
