Mianyang Guangxi Charging Pile Project
On board charging device refers to the device installed on the electric vehicle that uses the ground AC power grid and the on-board power supply to charge the battery pack, including the on-board charger (Figure 1-13), the on-board charging generator set and the operating energy recovery charging device. A AC power cable with a plug is directly inserted into the charging socket of the electric vehicle to charge the battery. On board charging devices usually use contact chargers with simple structure and convenient control, or inductive chargers. It is designed completely according to the type of on-board battery, with strong pertinence. Off board charging device, i.e. ground charging device, mainly includes special charger, special charging station, general charger, charging station for public places (Figure 1-14), etc. It can meet various charging modes of various batteries. Generally, the off board charger has large power, volume and weight to adapt to various charging modes.
Mianyang Guangxi Charging Pile Project
Safety requirements (1) The substation shall be equipped with safety bulletin board, warning board, safety signal light and alarm bell. (2) The warning sign of "Stop, High Voltage Danger" shall be hung outside the door of the high-voltage distribution room and transformer room or on the safety column of the substation. The warning signs must face the outside of the fence. (3) There shall be obvious operation instructions on the high-voltage distribution device. The grounding point of the equipment shall have obvious signs. (4) There should be obvious signs of "safe passage" or "emergency exit" in the room. In addition, the layout design of substation and distribution equipment shall facilitate installation, operation, handling, maintenance, test and monitoring. High and low voltage distribution room, transformer room, capacitor room and control room should not have unrelated pipes and lines passing through. New energy vehicles should first focus on cities, but the busy IX region is often short of land, and the cost of land is high. In this regard, the government needs to give preferential policies to promote the construction of charging facilities. The development and operation of electric vehicle charging stations by electric power enterprises have inherent advantages.
Mianyang Guangxi Charging Pile Project
Not only does China attach importance to the development of new energy charging equipment, foreign new energy companies are developing more rapidly, and French oil giant Total is also actively building charging equipment. In the early years, Total acquired Saft, a battery manufacturer. This company originally produced power batteries and provided automotive batteries for many automobile manufacturers. And some foreign companies have even developed wireless charging technology. They transmit wireless energy through magnetic induction between the charging coil and the receiver. The charging coil is buried under the ground. When it needs to be charged, just drive the car to an appropriate position to charge. New energy vehicles are very popular in recent years. Because of the environmental protection of new energy vehicles, many countries advocate new energy vehicles, and many people are interested in new energy vehicles. The New Energy Vehicle Technology Analysis has relevant content. Obviously, the trend of fuel vehicles has gone.
Mianyang Guangxi Charging Pile Project
AC type: Technical requirements for AC charging pile (plug) 1. Requirements for environmental conditions: ① Working environment temperature: - 20 ℃~+50 ℃; ② Relative humidity: 5%~95%; ③ Altitude: ≤ 1000m; ④ Installation site: outdoor; ⑤ Seismic capacity: ground horizontal acceleration 0.3g; Ground vertical acceleration 0.15g; The equipment shall be able to withstand three continuous sine waves under simultaneous action, and the safety factor shall be greater than 1.67; 2. Structural requirements: ① The shell of AC charging pile (bolt) shall be firm; ② In structure, it is necessary to prevent hands from easily touching the exposed part; ③ The AC charging post (bolt) shall be a steel composite structure with a thickness of more than 1.0, and the surface shall be treated with plastic immersion, and the requirements for heat dissipation shall be fully considered. The charging pile (bolt) shall have good shielding function against electromagnetic interference; ④ The charging pile (bolt) shall have sufficient support strength;
Mianyang Guangxi Charging Pile Project
With the gradual maturity of the entire new energy vehicle industry chain and the gradual release of market demand, the industry is about to erupt in 2018, but the problems of insufficient structural supply of charging infrastructure and the overall scale lag are increasingly prominent. It is urgent to make up for shortcomings and accelerate the construction of supporting infrastructure such as charging piles. How can we solve the problem of insufficient structural supply of charging infrastructure? Is there any successful case of innovative practice worth learning? There is a big gap in the charging pile. Under the global environment of resource conservation and green economy development, new energy vehicles are developing very rapidly. As the power guarantee of new energy vehicles, the charging pile is highly concerned by all circles. It can be said that the construction of charging infrastructure is one of the key factors affecting the promotion of new energy vehicles in China, and is more related to the development prospects of new energy vehicles.
Mianyang Guangxi Charging Pile Project
The country attaches great importance to the development of new energy vehicle charging equipment, and all regions will naturally increase efforts to promote development. Taking Nanning as an example, it is estimated that by 2020, there will be about 21550 new energy vehicles in Nanning. In order to meet the charging needs of the majority of car users, by 2020, Nanning will need nearly 20000 charging poles and nearly 100 charging stations. At present, the development of electric vehicle public charging equipment in Nanning is still in the primary stage. At present, the number of electric vehicles and the number of charging piles are seriously unbalanced, and the phenomenon of vehicles without piles and piles without vehicles occurs from time to time. The main reason is that the all smart service platform has not been built yet and needs further improvement.
