Price of Beihai Guangxi Charging Pile
9. Anti rust (anti oxidation) protection The iron shell of the charging pile (bolt) and the exposed iron support and parts shall be provided with double-layer anti rust measures, and the non-ferrous metal shell shall also be provided with anti oxidation protective film or anti oxidation treatment; 10. The wind protection charger installed on the platform and exposed parts shall be able to withstand the relative wind speed in different areas and at different heights specified in Table 9 of GB/T 4797.5-9 Natural Environmental Conditions for Electrical and Electronic Products - Precipitation and Wind; 11. The shell door of the anti-theft protection electric pile (bolt) shall be equipped with an anti-theft lock, and the bolt fixing the AC charging pile (bolt) must be installed or removed after opening the shell door; 12. The temperature rise requires that the AC charging pile (plug) operates continuously under rated load for a long time, and the temperature rise of internal heating elements and parts shall not exceed the provisions in Table 2 of Q/GDW 397 2009;
Price of Beihai Guangxi Charging Pile
The country attaches great importance to the development of new energy vehicle charging equipment, and all regions will naturally increase efforts to promote development. Taking Nanning as an example, it is estimated that by 2020, there will be about 21550 new energy vehicles in Nanning. In order to meet the charging needs of the majority of car users, by 2020, Nanning will need nearly 20000 charging poles and nearly 100 charging stations. At present, the development of electric vehicle public charging equipment in Nanning is still in the primary stage. At present, the number of electric vehicles and the number of charging piles are seriously unbalanced, and the phenomenon of vehicles without piles and piles without vehicles occurs from time to time. The main reason is that the all smart service platform has not been built yet and needs further improvement.
Price of Beihai Guangxi Charging Pile
How to properly charge in the hot link when using the charging pile of new energy vehicles? 1. Take care of your electric donkey and don't let it get sunburnt: in hot summer, you often sweat, and the rechargeable battery often "gets high fever". Here, it is recommended that the owner choose a place with a parking shed or a barrier to cover the electric vehicle as far as possible, and don't let the electric vehicle be exposed to the sun immediately, which will endanger the service life of the vehicle. In addition, fire accidents are very likely to occur under high temperatures. 2. Do not "steam up and cook down": the temperature is already hot. If the electric car is exposed to the sun at the moment, but you are charging the car, the rechargeable battery will generate heat in the whole process of charging. At this time, all cars are in the "steam up and cook down" mode, and you will "deploy" carelessly. 3. The electric vehicle must also take a proper "rest". 4. The charging time must be well controlled.
Price of Beihai Guangxi Charging Pile
According to the new national standard, the charging plug standard of different models in the future is the same. Xu Xinchao said, "Although there will be differences in voltage and power, theoretically it can be used in the same charging point. In addition, the new national standard attaches particular importance to the safety of the charging pile, which has always been the top priority. The standardized charging pile of new energy vehicles will automatically cut off power after charging, making breakthroughs in insulation and avoiding electric shock in rainy days, so as to avoid unnecessary dangers for new energy owners during charging. ".
Price of Beihai Guangxi Charging Pile
On board charging device refers to the device installed on the electric vehicle that uses the ground AC power grid and the on-board power supply to charge the battery pack, including the on-board charger (Figure 1-13), the on-board charging generator set and the operating energy recovery charging device. A AC power cable with a plug is directly inserted into the charging socket of the electric vehicle to charge the battery. On board charging devices usually use contact chargers with simple structure and convenient control, or inductive chargers. It is designed completely according to the type of on-board battery, with strong pertinence. Off board charging device, i.e. ground charging device, mainly includes special charger, special charging station, general charger, charging station for public places (Figure 1-14), etc. It can meet various charging modes of various batteries. Generally, the off board charger has large power, volume and weight to adapt to various charging modes.
Price of Beihai Guangxi Charging Pile
DC piles are the inevitable choice of public piles in the future: at present, the proportion of public AC and DC charging piles remains around 6:4, and the proportion of AC piles is more, mainly because in the early stage of the industry development, slow charging AC piles are very suitable for manufacturers to seize the market, relying on the characteristics of simple structure, mature technology and low cost, However, after the technology and market of charging piles become mature, DC piles are the inevitable choice for future public charging piles. The average charging time of the DC charging pile is 1 hour and 54 minutes. 85% of the users can finish charging within 2.5 hours, while the average charging time of the AC charging pile is 5 hours and 45 minutes. 66.2% of the users need more than 5 hours of lengthy charging time. The difference between the two nearly 4 hours of time directly determines the obvious use preference of the car owner Z.
