Luzhou Private Car Charging Pile Project
With the progress of people's life, consumers' requirements for cars are getting higher and higher, especially new energy vehicles. When consumers buy new energy vehicles, the first thing they should pay attention to is the battery and endurance of new energy vehicles, and then the charging of cars. Today, I will tell you about the charging pile of new energy vehicles. Is it GM? According to Xu Xinchao, the core of the charging national standard revision plan expected to be officially released in August this year is to standardize and unify the charging piles of new energy vehicles, and the charging sockets of different models will be unified.
Luzhou Private Car Charging Pile Project
Safety requirements (1) The substation shall be equipped with safety bulletin board, warning board, safety signal light and alarm bell. (2) The warning sign of "Stop, High Voltage Danger" shall be hung outside the door of the high-voltage distribution room and transformer room or on the safety column of the substation. The warning signs must face the outside of the fence. (3) There shall be obvious operation instructions on the high-voltage distribution device. The grounding point of the equipment shall have obvious signs. (4) There should be obvious signs of "safe passage" or "emergency exit" in the room. In addition, the layout design of substation and distribution equipment shall facilitate installation, operation, handling, maintenance, test and monitoring. High and low voltage distribution room, transformer room, capacitor room and control room should not have unrelated pipes and lines passing through. New energy vehicles should first focus on cities, but the busy IX region is often short of land, and the cost of land is high. In this regard, the government needs to give preferential policies to promote the construction of charging facilities. The development and operation of electric vehicle charging stations by electric power enterprises have inherent advantages.
Luzhou Private Car Charging Pile Project
DC piles are the inevitable choice of public piles in the future: at present, the proportion of public AC and DC charging piles remains around 6:4, and the proportion of AC piles is more, mainly because in the early stage of the industry development, slow charging AC piles are very suitable for manufacturers to seize the market, relying on the characteristics of simple structure, mature technology and low cost, However, after the technology and market of charging piles become mature, DC piles are the inevitable choice for future public charging piles. The average charging time of the DC charging pile is 1 hour and 54 minutes. 85% of the users can finish charging within 2.5 hours, while the average charging time of the AC charging pile is 5 hours and 45 minutes. 66.2% of the users need more than 5 hours of lengthy charging time. The difference between the two nearly 4 hours of time directly determines the obvious use preference of the car owner Z.
Luzhou Private Car Charging Pile Project
There are four main pain points: A. Battery standardization is too difficult. The separation of vehicle and electricity first requires the standardization of power batteries, BMS standardization, interface standardization, and software management standardization. Any vehicle upgrade must be compatible with the previous generation of products. Battery standardization is too difficult. Every car company wants to make its own electricity exchange standard. It is unrealistic for so many car companies to unify. B. The investment is large and the cost is high. The replacement of power needs to lay a large network, and the investment scale is far greater than charging. Build a power exchange network for a city to provide special tram exchange services. The cost can be recovered only after at least 6-8 years or even more. C. The deflagration hazard of the power plant is large, and the safety hazard is huge. D. It is difficult to improve the customer experience.
Luzhou Private Car Charging Pile Project
Although the proportion of new energy vehicles is increasing year by year, its absolute number is much less than that of fuel vehicles. According to the reporter, consumers are dissatisfied with new energy vehicles (mainly pure electric vehicles) mainly in the following two aspects: first, there are relatively few charging piles and charging time is long. Although it is convenient to install by yourself, it is an indisputable fact that in a big city like Beijing, there are only a few parking spaces of their own, and most of them are parked at the roadside. Second, the endurance mileage is not long enough. If you travel far, you will be in trouble once you cannot find the charging post. Chen Qingtai, president of the China Electric Vehicle Hundred People Association, believes that the basis for the rapid growth of electric vehicles is that the cost performance and convenience of electric vehicles should reach or exceed that of fuel vehicles. Therefore, in addition to technological progress, charging infrastructure construction must also keep pace.
Luzhou Private Car Charging Pile Project
What should be paid attention to when charging electric vehicle batteries? When the electric vehicle starts and goes uphill, it is necessary to avoid emergency braking and acceleration as much as possible, because large current discharge will be formed during this process, which will damage the performance of the battery. There are also two points that need special attention when stopping for a long time. 1. Parking without power supply should be avoided: unlike traditional gasoline vehicles, electric vehicles have their own "unique taste" for the state of vehicle parking. If the "hungry stomach" is used too long, it will "rebel". When the electric vehicle is parked in the case of power loss, the battery is prone to sulfation, blocking the electric ion channel, resulting in insufficient charging and declining battery capacity. 2. Deep discharge shall be carried out regularly: when the electric vehicle is almost out of power, undervoltage protection will automatically occur, but during this process, its voltage is unstable, and it will also be up and down, causing repeated undervoltage protection status
